WiFi Pineapple Mark VII
  • WiFi Pineapple Mark VII
  • Setup
    • Connecting the WiFi Pineapple
    • Setting up your WiFi Pineapple
    • Connecting to the WiFi Pineapple on Linux
    • Connecting to the WiFi Pineapple on Windows
    • Setting up the WiFi Pineapple over WiFi
    • Setup by USB Disk
  • UI Overview
    • Introduction to the UI
    • Dashboard
    • Campaigns
    • PineAP
    • Recon
    • Handshakes
    • Modules
    • Settings
    • Cloud C²
  • Developer Documentation
    • Developer Resources
    • Contributing to the Module Repository
  • WiFi Basics
    • Introduction to WiFi
    • Radios and Chipsets
    • Stations and APs
    • Transmit Power
    • Antennas
    • Channels and Regions
    • Protocols
    • Modes of Operation
    • Logical Configurations
    • MAC Addresses
    • Broadcast and Multicast MAC Addresses
    • SSIDs
    • 802.11 Frame Types
    • 802.11 Frame Structure
    • Management Frames
    • Frame Injection
    • Association and State
  • FAQ / Troubleshooting
    • MacOS Support
    • Establishing an Internet Connection
      • Configuring a Client Mode Connection
      • ICS on Linux
      • Configuring ICS on Windows
      • Configuring a USB Ethernet Adapter
    • Password Reset
    • Factory Reset and Recovery
    • WiFi Pineapple Updates
    • WiFi Pineapple Beta Updates
    • Compatible 802.11ac Adapters
  • Extras
    • MK7 LED Mod Installation
    • MK7 Kismet Case Installation
Powered by GitBook
On this page

Was this helpful?

  1. Extras

MK7 LED Mod Installation

Last updated 3 years ago

Was this helpful?

The MK7 LED mod is an add-on board for the Hak5 WiFi Pineapple Mark VII which adds some bling and fun LEDs. Proceeds from the case help support Kismet development, too!

See the install instructions from .

https://www.kismetwireless.net/mk7-led-mod/