WiFi Pineapple Mark VII
  • WiFi Pineapple Mark VII
  • Setup
    • Connecting the WiFi Pineapple
    • Setting up your WiFi Pineapple
    • Connecting to the WiFi Pineapple on Linux
    • Connecting to the WiFi Pineapple on Windows
    • Setting up the WiFi Pineapple over WiFi
    • Setup by USB Disk
  • UI Overview
    • Introduction to the UI
    • Dashboard
    • Campaigns
    • PineAP
    • Recon
    • Handshakes
    • Modules
    • Settings
    • Cloud C²
  • Developer Documentation
    • Developer Resources
    • Contributing to the Module Repository
  • WiFi Basics
    • Introduction to WiFi
    • Radios and Chipsets
    • Stations and APs
    • Transmit Power
    • Antennas
    • Channels and Regions
    • Protocols
    • Modes of Operation
    • Logical Configurations
    • MAC Addresses
    • Broadcast and Multicast MAC Addresses
    • SSIDs
    • 802.11 Frame Types
    • 802.11 Frame Structure
    • Management Frames
    • Frame Injection
    • Association and State
  • FAQ / Troubleshooting
    • MacOS Support
    • Establishing an Internet Connection
      • Configuring a Client Mode Connection
      • ICS on Linux
      • Configuring ICS on Windows
      • Configuring a USB Ethernet Adapter
    • Password Reset
    • Factory Reset and Recovery
    • WiFi Pineapple Updates
    • WiFi Pineapple Beta Updates
    • Compatible 802.11ac Adapters
  • Extras
    • MK7 LED Mod Installation
    • MK7 Kismet Case Installation
Powered by GitBook
On this page
  • Configuration via GUI
  • Configuration via CLI

Was this helpful?

  1. Setup

Connecting to the WiFi Pineapple on Linux

This guide teaches the basics of connecting to the WiFi Pineapple on Linux-based operating systems.

Last updated 3 years ago

Was this helpful?

Configuration via GUI

To configure the WiFi Pineapple's USB Ethernet interface, you can use the NetworkManager GUI commonly included in Linux distributions.

  1. Connect the WiFi Pineapple to your computer via the USB-C cable.

  2. Once the device has fully booted, open your computers networking settings.

  3. Find the new USB Ethernet device, and configure it to use the following IPv4 settings:

    1. IP: 172.16.42.42

    2. Netmask: 255.255.255.0

    3. Gateway: Unset, or 0.0.0.0

You may need to disconnect and reconnect the interface for your changes to take place.

Configuration via CLI

To configure the WiFi Pineapple's USB Ethernet interface via the command line, you can make use of the ip tools commonly included in Linux distributions.

  1. Connect the WiFi Pineapple to your computer via the USB-C cable.

  2. Once the device has fully booted, open the Terminal emulator and run the following:

$ sudo ip link set eth0 down
$ sudo ip addr add 172.16.42.42/255.255.255.0 dev eth0
$ sudo ip link set eth0 up