Signal Owl
  • Signal Owl by Hak5
  • Getting Started
    • First Time Setup
    • Signal Owl Basics
    • Default Settings
    • USB Flash Disk Support
    • LED Status Indications
    • Adding Payloads and Payload Extensions
  • Internet Connectivity
    • Getting the Signal Owl Online
  • Software Updates
    • Upgrading Firmware
  • Payload Development
    • Payload Development Basics
    • The LED Command
    • The C2DISCONNECT Command
    • The C2EXFIL Command
    • The C2CONNECT Command
    • Included Tools
    • Extensions
  • Troubleshooting
    • Troubleshooting FAQ
Powered by GitBook
On this page

Was this helpful?

  1. Troubleshooting

Troubleshooting FAQ

Out of the box my Signal Owl is not flashing the upgrade-x.x.x.bin file from my USB flash disk.

Make sure that the USB flash disk is formatted in FAT32 or EXT3/EXT4 filesystem and has a single partition. A newly formatted USB disk works best. Also make sure that the upgrade file has not been renamed, and that it is located on the root of the USB flash disk.

I can connect to the Owl_xxxx WiFi SSID in Arming mode, however I can't access the shell via SSH

The first time the Signal Owl boots into Arming mode, SSH keys are generated. This process can take a few minutes - during which time the SSH server will be inaccessible. Leave the Signal Owl in Arming mode for a few minutes, then try again.

Last updated 3 years ago

Was this helpful?