Signal Owl
  • Signal Owl by Hak5
  • Getting Started
    • First Time Setup
    • Signal Owl Basics
    • Default Settings
    • USB Flash Disk Support
    • LED Status Indications
    • Adding Payloads and Payload Extensions
  • Internet Connectivity
    • Getting the Signal Owl Online
  • Software Updates
    • Upgrading Firmware
  • Payload Development
    • Payload Development Basics
    • The LED Command
    • The C2DISCONNECT Command
    • The C2EXFIL Command
    • The C2CONNECT Command
    • Included Tools
    • Extensions
  • Troubleshooting
    • Troubleshooting FAQ
Powered by GitBook
On this page

Was this helpful?

  1. Payload Development

The C2DISCONNECT Command

While writing payloads for Hak5 devices you can control the C2 Connection state.

To disconnect your device from Cloud C2 run the following command: C2DISCONNECT

Last updated 3 years ago

Was this helpful?