WiFi Pineapple - 6th Gen: NANO / TETRA
  • WiFi Pineapple NANO/TETRA
  • Getting Started
    • About the WiFi Pineapple NANO/TETRA
    • The WiFi Auditing Workflow
    • The PineAP Suite
    • The Web Interface
    • Upgrading the Firmware
  • Setup
    • Setup Basics
    • WiFi Pineapple NANO - Linux Setup
    • WiFi Pineapple NANO - Windows Setup
    • WiFi Pineapple TETRA - Linux Setup
  • Internet Connectivity
    • Internet Connectivity Basics
    • Internet Connection Sharing on Kali Linux
    • Internet Connection Sharing over Ethernet in Windows
    • Internet Connection Sharing over Ethernet in Linux
    • Wired Internet Connection
    • WiFi Client Mode
  • Console Access
    • Console Access Basics
    • Secure Shell
    • Serial Access - WiFi Pineapple TETRA
    • Working with PineAP from the CLI
  • Basics of WiFi Operation
    • Basics of WiFi Operation
    • Radios and Chipsets
    • Stations and Base Stations
    • Transmit Power
    • Channels and Regions
    • Protocols
    • Modes of Operation
    • Logical Configurations
    • MAC Address
    • Broadcast Address
    • Service Sets and Identifiers
    • Management Frames
    • Frame Types
    • Frames and Frame Structure
    • Frame Injection
    • Association States
  • FAQ / Troubleshooting
    • Serial Console on the WiFi Pineapple TETRA
    • Ethernet on the WiFi Pineapple TETRA
    • LED Status Indicators
    • Power Considerations
    • Factory Reset
    • Firmware Recovery
    • Manual Firmware Installation
  • Development
    • Legacy WiFi Pineapple Mark V Modules (Infusions)
    • Specifications and Power Considerations
    • WiFi Pineapple NANO/TETRA Module API - Introduction
    • WiFi Pineapple NANO/TETRA Module API - Authentication
    • WiFi Pineapple NANO/TETRA Module API - Modules
    • WiFi Pineapple NANO/TETRA Module API - module.php API
    • Creating WiFi Pineapple NANO/TETRA Modules
Powered by GitBook
On this page
  1. FAQ / Troubleshooting

LED Status Indicators

WiFi Pineapple NANO The single blue LED indicates bootup and WiFi operation. While starting up, the LED will flash. Once bootup has completed the LED will become solid. The LED will flicker to indicate activity on the first WiFi radio – wlan0. This radio is host to the Access Point.

WiFi Pineapple TETRA The yellow LED indicates activity on the WAN eth0 RJ45 Ethernet port. The blue LED indicates activity on the wlan0 wireless interface, home to the access point. The red LED indicates activity on the wlan1mon wireless interface, used by PineAP and other applications for sniffing and injection.

The boot sequence is: yellow solid followed by a moment of no LED activity, then blue blinking until bootup is complete.

PreviousEthernet on the WiFi Pineapple TETRANextPower Considerations

Last updated 3 years ago