WiFi Pineapple - 6th Gen: NANO / TETRA
  • WiFi Pineapple NANO/TETRA
  • Getting Started
    • About the WiFi Pineapple NANO/TETRA
    • The WiFi Auditing Workflow
    • The PineAP Suite
    • The Web Interface
    • Upgrading the Firmware
  • Setup
    • Setup Basics
    • WiFi Pineapple NANO - Linux Setup
    • WiFi Pineapple NANO - Windows Setup
    • WiFi Pineapple TETRA - Linux Setup
  • Internet Connectivity
    • Internet Connectivity Basics
    • Internet Connection Sharing on Kali Linux
    • Internet Connection Sharing over Ethernet in Windows
    • Internet Connection Sharing over Ethernet in Linux
    • Wired Internet Connection
    • WiFi Client Mode
  • Console Access
    • Console Access Basics
    • Secure Shell
    • Serial Access - WiFi Pineapple TETRA
    • Working with PineAP from the CLI
  • Basics of WiFi Operation
    • Basics of WiFi Operation
    • Radios and Chipsets
    • Stations and Base Stations
    • Transmit Power
    • Channels and Regions
    • Protocols
    • Modes of Operation
    • Logical Configurations
    • MAC Address
    • Broadcast Address
    • Service Sets and Identifiers
    • Management Frames
    • Frame Types
    • Frames and Frame Structure
    • Frame Injection
    • Association States
  • FAQ / Troubleshooting
    • Serial Console on the WiFi Pineapple TETRA
    • Ethernet on the WiFi Pineapple TETRA
    • LED Status Indicators
    • Power Considerations
    • Factory Reset
    • Firmware Recovery
    • Manual Firmware Installation
  • Development
    • Legacy WiFi Pineapple Mark V Modules (Infusions)
    • Specifications and Power Considerations
    • WiFi Pineapple NANO/TETRA Module API - Introduction
    • WiFi Pineapple NANO/TETRA Module API - Authentication
    • WiFi Pineapple NANO/TETRA Module API - Modules
    • WiFi Pineapple NANO/TETRA Module API - module.php API
    • Creating WiFi Pineapple NANO/TETRA Modules
Powered by GitBook
On this page
  1. FAQ / Troubleshooting

Factory Reset

PreviousPower ConsiderationsNextFirmware Recovery

Last updated 3 years ago

This article applies to the WiFi Pineapple NANO and TETRA. WiFi Pineapple Mark VII users please see the .

Settings may be restored to defaults using the factory reset procedure. This process will restore the device to the initial configuration of the latest installed firmware. Upon performing the factory reset procedure initial setup must be performed, setting the root password and SSID.

To perform a factory reset from a fully booted WiFi Pineapple, hold the RESET button for approximately 7 seconds. The device will then reboot.

Alternatively the factory reset may be performed from the web interface. From the Configuration page, select Factory Reset from the General menu.

Note: data not stored on external media (USB / SD) will be erased during this process.

Mark VII Documentation