WiFi Pineapple - 6th Gen: NANO / TETRA
  • WiFi Pineapple NANO/TETRA
  • Getting Started
    • About the WiFi Pineapple NANO/TETRA
    • The WiFi Auditing Workflow
    • The PineAP Suite
    • The Web Interface
    • Upgrading the Firmware
  • Setup
    • Setup Basics
    • WiFi Pineapple NANO - Linux Setup
    • WiFi Pineapple NANO - Windows Setup
    • WiFi Pineapple TETRA - Linux Setup
  • Internet Connectivity
    • Internet Connectivity Basics
    • Internet Connection Sharing on Kali Linux
    • Internet Connection Sharing over Ethernet in Windows
    • Internet Connection Sharing over Ethernet in Linux
    • Wired Internet Connection
    • WiFi Client Mode
  • Console Access
    • Console Access Basics
    • Secure Shell
    • Serial Access - WiFi Pineapple TETRA
    • Working with PineAP from the CLI
  • Basics of WiFi Operation
    • Basics of WiFi Operation
    • Radios and Chipsets
    • Stations and Base Stations
    • Transmit Power
    • Channels and Regions
    • Protocols
    • Modes of Operation
    • Logical Configurations
    • MAC Address
    • Broadcast Address
    • Service Sets and Identifiers
    • Management Frames
    • Frame Types
    • Frames and Frame Structure
    • Frame Injection
    • Association States
  • FAQ / Troubleshooting
    • Serial Console on the WiFi Pineapple TETRA
    • Ethernet on the WiFi Pineapple TETRA
    • LED Status Indicators
    • Power Considerations
    • Factory Reset
    • Firmware Recovery
    • Manual Firmware Installation
  • Development
    • Legacy WiFi Pineapple Mark V Modules (Infusions)
    • Specifications and Power Considerations
    • WiFi Pineapple NANO/TETRA Module API - Introduction
    • WiFi Pineapple NANO/TETRA Module API - Authentication
    • WiFi Pineapple NANO/TETRA Module API - Modules
    • WiFi Pineapple NANO/TETRA Module API - module.php API
    • Creating WiFi Pineapple NANO/TETRA Modules
Powered by GitBook
On this page
  1. Basics of WiFi Operation

Stations and Base Stations

Technically speaking in regards to the architecture of any wireless network, each component is referred to as a station (STA). There are two categories of stations in an infrastructure mode WiFi setup — the base station (access point) and station (client). Be aware of this terminology as it may come up in other programs and documentation. Generally the WiFi Pineapple will refer to base stations as their more common name, access point or simply AP, and stations as clients or client devices.

PreviousRadios and ChipsetsNextTransmit Power

Last updated 3 years ago