Shark Jack
  • The Shark Jack by Hak5
  • Getting Started
    • Shark Jack Basics
    • Default Settings
  • Beginner Guides
    • Unboxing and Setup
    • Using sharkjack.sh
    • Two Key Commands
    • Writing a Simple Payload
  • Software Updates
    • Manual Upgrade
    • Over-the-Air Upgrade
  • Writing Payloads
    • Payload Development Basics
    • The NETMODE Command
    • The LED Command
    • The SWITCH Command
    • The BATTERY Command
    • The SERIAL_WRITE Command
    • The Cloud C2 commands
    • Included Tools
  • Managing Payloads
    • The UPDATE_PAYLOADS Command
    • The LIST Command
    • The ACTIVATE Command
  • Troubleshooting
    • Firmware Recovery
  • Tips & Tricks
    • Charge the Shark Jack from your Phone
    • Using the Shark Jack with the Plunder Bug as a simple switch
    • Android Serial Setup for Shark Jack Cable
  • Product Information
    • Specifications
    • Important Safety Information and Warnings
Powered by GitBook
On this page

Was this helpful?

  1. Tips & Tricks

Using the Shark Jack with the Plunder Bug as a simple switch

Last updated 3 years ago

Was this helpful?

In a way, the Plunder Bug can be used as a simple switch. In the following example, the Plunder Bug is used to provide the laptop (via USB-C) and the Shark Jack (or any ordinary Ethernet device) network access via the WAN/Uplink port (closest to the Plunder Bug's status LED).