Packet Squirrel
  • Packet Squirrel by Hak5
  • Getting Started
    • Packet Squirrel Basics
    • USB Flash Disk Support
    • Default Settings
    • LED Status Indications
    • Selecting and Adding Payloads
  • Default Payloads
    • Logging Network Traffic
    • Spoofing DNS
    • OpenVPN Payload
  • Internet Connectivity
    • Getting the Packet Squirrel Online
  • Software Updates
    • Upgrading Firmware
    • Manual Upgrade
  • Payload Development
    • Payload Development Basics
    • Ducky Script for Packet Squirrel
    • The NETMODE Command
    • The LED Command
    • The SWITCH Command
    • The BUTTON Command
    • Included Tools
  • Troubleshooting
    • Firmware Recovery
    • Factory Reset
    • FAQ
Powered by GitBook
On this page

Was this helpful?

  1. Troubleshooting

Firmware Recovery

Last updated 3 years ago

Was this helpful?

Holding the push button for 3-7 seconds while powering on the device in the arming mode will enable access to the firmware recovery web console. From this mode you can browse to the recovery console at from a computer connected to the Ethernet In port.

In some cases where an IP address is not obtained from the Packet Squirrel’s DHCP server, a static IP address must be set within the 192.168.1.x range in order to access the firmware recovery web console.

Download the factory recovery image from the .

http://192.168.1.1
squirrel-recovery.bin
Hak5 Download Center