Packet Squirrel
  • Packet Squirrel by Hak5
  • Getting Started
    • Packet Squirrel Basics
    • USB Flash Disk Support
    • Default Settings
    • LED Status Indications
    • Selecting and Adding Payloads
  • Default Payloads
    • Logging Network Traffic
    • Spoofing DNS
    • OpenVPN Payload
  • Internet Connectivity
    • Getting the Packet Squirrel Online
  • Software Updates
    • Upgrading Firmware
    • Manual Upgrade
  • Payload Development
    • Payload Development Basics
    • Ducky Script for Packet Squirrel
    • The NETMODE Command
    • The LED Command
    • The SWITCH Command
    • The BUTTON Command
    • Included Tools
  • Troubleshooting
    • Firmware Recovery
    • Factory Reset
    • FAQ
Powered by GitBook
On this page

Was this helpful?

  1. Troubleshooting

Factory Reset

Settings may be restored to defaults using the factory reset procedure. This process will restore the device to the initial configuration of the latest installed firmware. Upon performing the factory reset procedure, all settings including password will be reset. To perform a factory reset from a fully booted Packet Squirrel, hold the push button for approximately 7 seconds. The device will then reboot.

Last updated 3 years ago

Was this helpful?