Packet Squirrel
  • Packet Squirrel by Hak5
  • Getting Started
    • Packet Squirrel Basics
    • USB Flash Disk Support
    • Default Settings
    • LED Status Indications
    • Selecting and Adding Payloads
  • Default Payloads
    • Logging Network Traffic
    • Spoofing DNS
    • OpenVPN Payload
  • Internet Connectivity
    • Getting the Packet Squirrel Online
  • Software Updates
    • Upgrading Firmware
    • Manual Upgrade
  • Payload Development
    • Payload Development Basics
    • Ducky Script for Packet Squirrel
    • The NETMODE Command
    • The LED Command
    • The SWITCH Command
    • The BUTTON Command
    • Included Tools
  • Troubleshooting
    • Firmware Recovery
    • Factory Reset
    • FAQ
Powered by GitBook
On this page

Was this helpful?

  1. Payload Development

Ducky Script for Packet Squirrel

Ducky Script is the payload language of Hak5 gear. It consisting of a number of simple commands specific to the Packet Squirrel hardware and the full power of Bash. Theses payloads, named payload.txt, execute on boot by the Packet Squirrel depending on switch position.

Basic Ducky Script command for the Packet Squirrel include:

COMMAND

Description

NETMODE

Specifies the networking mode to NAT, BRIDGE, TRANSPARENT or VPN.

LED

Control the RGB LED. Accepts color and pattern or payload state.

BUTTON

Pauses the payload for a specified time or until the button is pressed.

SWITCH

Reports the current switch position.

Last updated 3 years ago

Was this helpful?