Holding the push button for 3-7 seconds while powering on the device in the arming mode will enable access to the firmware recovery web console. From this mode you can browse to the recovery console at http://192.168.1.1 from a computer connected to the Ethernet In port.
In some cases where an IP address is not obtained from the Packet Squirrel’s DHCP server, a static IP address must be set within the 192.168.1.x range in order to access the firmware recovery web console.
Download the squirrel-recovery.bin factory recovery image.
SHA256 sum: f4f724929b9c314a34885346c8b7d381760f21015fb2452151333744e6b58867
Settings may be restored to defaults using the factory reset procedure. This process will restore the device to the initial configuration of the latest installed firmware. Upon performing the factory reset procedure, all settings including password will be reset. To perform a factory reset from a fully booted Packet Squirrel, hold the push button for approximately 7 seconds. The device will then reboot.